| Customization: | Available |
|---|---|
| Tile Type: | Gi, PPGI, Aluminum,Stainless Steel,Colored Steel |
| Certification: | CE, SGS |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| ROLL FORMING MACHINE FOR CABLE TRAY PROFILE | |
| Material Specification | |
| Thickness | 1.0mm to 2.5mm |
| Material | GI |
| Yield strength | 250MPa or customized |
| Machine Components | |
| 5Ton*1250mm Hydraulic Decoiler and Pre-Leveling Device | |
| Coil inner hole expanding | Hydraulic system, 3KW pump motor |
| Driving motor | 7.5KW, with frequency inverter |
| Expanding type | Taper wedge expanding system |
| Load capacity | Max.5Tons |
| Coil inner diameter | 510±30mm |
| Coil outer diameter | Max.1600mm |
| Coil width | Max.1250mm |
| Stop/start rotation | Automatic stopping device with limited switch to assist |
| Pre-Level Device with 4 over 3 shafts to remove the Coil-set, Manual control | |
| 80 Tons Press with Servo Feeder | |
| Feeder | 3.0KW servo motor to drive |
| Stroke | 45m/min |
| Punching mold | One set, with different mold cores to get different quantity of holes punched |
| Mateiral of punching mold | Cr12Mov, heat treatment |
| Holes patten | As the drawing shown |
| Feed-in and Pre-leveling Device | |
| Two rollers for feeding in | |
| Pre-Leveling Device with 3 over 2 shafts to remove the Coil-set, Manual control | |
| Hydraulic Pre-shearing Device and Pre-punching Device | |
| Hydraulic pre-shearing device, cut to length control,to cut off the end of the final piece of sheet only | |
| Punching and notching mould | One set, to punch flange holes and flange notch |
| Share the same hydraulic station with pre-punching and pre-notching device The following picture is for your reference |
|
| Roll Forming Machine | |
| Driving system | Gear/sprocket |
| Forming station | 22 stations |
| Roller material | Cr12, heat treatment |
| Shaft | Φ75mm, 45# steel, sliding parts with hard chrome coated |
| Main motor | 22KW, frequency speed control |
| Size changing | 1.1KW+0.75KW×2 |
| Line speed of rollformer | Approx. 15m/min or customized |
| Hydraulic Multi-size Cutting Device | |
| Pneumatic pin to locate, cutting off while the programmed length is reached, stop to cut | |
| Cutting device is movable on the linear rail | |
| Cutting type | Slug breaker |
| Cuttting tool | Including one set of cutting blades for all sizes |
| Cutting tool material | Cr12, Heat treatment |
| Hydraulic station | 11KW |
| PLC Control System | |
| Function | Control quantity, punching and cutting length automatically |
| PLC | Siemens |
| Touch screen | Siemens |
| Inverter | Schneider |
| Encoder | Omron |
| Cut-to-length tolerance | ≤±2.0 mm |
| Control Voltage | 24V |
| Product Rack | 3 meters×2 |
){kind=link}